Mars rover Curiosity’s software upgraded(firstpost.com)
firstpost.com
Mars rover Curiosity’s software upgraded
http://www.firstpost.com/tech/mars-rover-curiositys-software-upgraded-1301509.html
7 comments
Thanks for the links, I figured that the lack of compliance in the "tire" section of the wheels would be an issue but that is a bit more damage than I would expect. I am guessing that under some driving conditions you might get up to 50% of the rover weight on a wheel and if that was while the wheel was rolling over a rock, the tendency would be to cut into the aluminium. So one wonders why not titanium outer rims? or a compliance system that would allow the wheel to deform until enough weight had been distributed across enough surface area to keep it under the 'minimal damage' threshold.
Considering the hole is non-structural and it's more than halfway through the original planned mission duration, those wheels look fine to me!
I wouldn't mind seeing the progression, though, since they say it's accelerated recently on the rough terrain.
I wouldn't mind seeing the progression, though, since they say it's accelerated recently on the rough terrain.
"It appears to be correlated with driving over rougher terrain."
Who'd have thought....
Who'd have thought....
When I read the article that also popped out for me.
Unbelievably obvious. Obviously somethings are different in the Martian environment, but the laws of physics didn't just look the other way when they saw the rover coming.
Unbelievably obvious. Obviously somethings are different in the Martian environment, but the laws of physics didn't just look the other way when they saw the rover coming.
I get nervous sometimes when flashing ROMs on my phone...And those were downloaded over a (comparatively) 0-latency connection with high throughput. Fact that sending a firmware to Mars is apparently a normal thing now notwithstanding, I find this incredible.
The rover has got two computers though and during upgrades only one is updated. If something goes wrong, the non-updated one takes over and they can restore the last working state. Phones are easy to brick since they lack a backup system.
The ease with which many consumer devices can be bricked by firmware updates is really ridiculous, though. You don't need full hardware redundancy to virtually eliminate them, just a redundant OS partition and a little sane engineering. At that point, any bricking is almost certain to be the result of an actual hardware failure, which is its own problem.
I haven't seen an easily brickable device for half a decade now... Android smartphones and tablets are very hard to brick, post-2008 laptops and motherboards have excellent BIOS recovery, what else is there? I bricked an external RAID enclosure by flashing the wrong firmware, but that POS was running on a SiliconImage chip that for some reason allowed flashing a completely different firmware to it...
Funny, I just saw a friend's Android phone get bricked by an update about two years ago. It was in a state I probably could have recovered it from if its bootloader were unlocked, but it was beyond reach of Joe User.
I've also bricked or seen bricked routers, external HDDs, and TVs in the last five years.
Many TVs, actually, if you include pre-release units. As far as I can tell, most of them rely entirely on testing to avoid bricking devices. They make zero provision for the inevitable case where something goes wrong. Power failures during updates remain a frequent cause of bricking.
Your "exception" is quite a common case when firmware updates are performed manually. Those failures have, of course, dropped dramatically since devices started being able to self-update, but they're far from the only such failures out there. The "some reason" depends on the product and manufacturer, but it's usually a combination of laziness and penny-pinching. Somebody didn't want to do the work, or somebody else didn't want to pay for it to be done.
I've seen the processes that lead to these situations up-close. There are a lot of engineers out there who don't think about failure modes, and a lot of managers who dismiss the engineers who do as paranoid and/or troublemakers.
I've also bricked or seen bricked routers, external HDDs, and TVs in the last five years.
Many TVs, actually, if you include pre-release units. As far as I can tell, most of them rely entirely on testing to avoid bricking devices. They make zero provision for the inevitable case where something goes wrong. Power failures during updates remain a frequent cause of bricking.
Your "exception" is quite a common case when firmware updates are performed manually. Those failures have, of course, dropped dramatically since devices started being able to self-update, but they're far from the only such failures out there. The "some reason" depends on the product and manufacturer, but it's usually a combination of laziness and penny-pinching. Somebody didn't want to do the work, or somebody else didn't want to pay for it to be done.
I've seen the processes that lead to these situations up-close. There are a lot of engineers out there who don't think about failure modes, and a lot of managers who dismiss the engineers who do as paranoid and/or troublemakers.
> it was beyond reach of Joe User.
I would argue that this is not bricking, if it's beyond joe user that's just a job for experts.
Bricking to me is totally gone with no hope of recovery.
I would argue that this is not bricking, if it's beyond joe user that's just a job for experts.
Bricking to me is totally gone with no hope of recovery.
> I just saw...about two years ago.
Well, that is not just seeing, and it probably was not bricked in the traditional sense. It may have been a pain to try to recover, but it was probably possible.
Well, that is not just seeing, and it probably was not bricked in the traditional sense. It may have been a pain to try to recover, but it was probably possible.
Oh yeah, routers and hard drives. Well, DDWRT runs fine and WDidle3 didn't brick any of my WD drives, so I guess I'm lucky! No TV in this home, either :-)
The first attempt at this upgrade did have some issues:
http://www.jpl.nasa.gov/news/news.php?release=2013-325
The software reset and booted back into the older version. There are some really good safeguards against bricking anything, but it's still scary. Especially with the data latencies involved - in this case the team had several hours between knowing "something's wrong" and getting more data.
http://www.jpl.nasa.gov/news/news.php?release=2013-325
The software reset and booted back into the older version. There are some really good safeguards against bricking anything, but it's still scary. Especially with the data latencies involved - in this case the team had several hours between knowing "something's wrong" and getting more data.
A lot of work has gone into making that software especially robust, including some custom tooling for facilitating peer review. Dr. Holzmann (formerly of Bell Labs, birthplace of Unix) heads JPL's Laboratory for Reliable Software to lead this work.
If you'd like to learn more, I written about the LARS methodology after hearing Dr. Holzmann at USENIX Hot Topics in Dependable Software: http://www.verticalsysadmin.com/making_robust_software/
If you'd like to learn more, I written about the LARS methodology after hearing Dr. Holzmann at USENIX Hot Topics in Dependable Software: http://www.verticalsysadmin.com/making_robust_software/
And here is some more on Gerard's setup:
http://gerard.holzmann.usesthis.com
http://gerard.holzmann.usesthis.com
Fascinating, this type of programming has always interested me (as I was a desktop developer who moved to the web) but not something I think I'd want to do (the stress alone must be horrific when you work on any mission critical/safety critical software).
Possibly cool idea: build a Curiosity emulator/simulator. Build the o.s. for it and/or user-space (does any of those concepts apply? probably not) software for it.
Does this already exist? This looks like it. http://sourceforge.net/projects/marsroversim/
Does this already exist? This looks like it. http://sourceforge.net/projects/marsroversim/
Curiosity definitely has an OS (VxWorks). But I asked one of the developers about releasing some code after Curiosity landed and was told that they couldn't. So I doubt an accurate Curiosity emulator will ever be possible unless JPL releases their code 45 years from now like NASA did with Apollo 11's guidance system. (https://code.google.com/p/virtualagc/)
I believe that the software technically falls under certain US export restrictions which is probably one reason it isn't made public.
US export restrictions? Can't export it much further than Mars. ;-)
They usually have terrestrial duplicates where tests occur and bug troubleshooting is done
[deleted]
It's so cool that we can stream software updates across 34 million miles.
It's also cool that the update was sent partly through the MRO spacecraft, then forwarded down to the surface.
A day later...
"Adobe Acrobat Reader needs to update"
[1] http://news.discovery.com/space/martian-wear-and-tear-curios...
[2] http://www.planetary.org/blogs/emily-lakdawalla/2013/1002210...