There is an Australian company making something similar. http://www.gizmo3dprinters.com.au/
They expect to launch their kickstarter project by end of year.
I second this. http://i.materialise.com/ is decent too, but Sculpteo is the best I've used. Their standard service is very fast, and the prices for the small stuff I typically print is much cheaper than the others.
Looking at the Replicator2 specs vs Formlabs.
I see that Makerbot lists layer height and XY resolution as 100 microns, while Formlabs has layer height as 25 microns, but XY as 300 microns. Does the improvement in layer height matter much when the XY resolution isn't as accurate? What I'm basically wondering is are you only as good your least accurate spec?