I am currently designing PCBs for my next post using EasyEDA, anything to pay attention to?

I'm especially concerned about the track width and clearance and stuff. For 12V and I think a max of 8A I calculated 2mm width, 0.6mm clearance, 1.5mm via diameter and 0.75mm via drill diameter.

Athrunen

·7 anni fa·discuss

Thanks for that information, but I learned that the esp32 is not 5V tolerant the hard way. ^^

Will fix the bit about the PWM in a second

Athrunen

·7 anni fa·discuss

Thank you, now I want to learn about hdl. ^^

Languagevise coming from C# and learning c or c++ for low-level programming was quite smooth, also coming from python was the hard part, that was a lot of comforts I had to give up.

But as I am also learning some micropython, I might write about porting stuff to it in the future.

Athrunen

·7 anni fa·discuss

Thank you, the surprising amount of attention this got kinda hugged my website to death earlier ^^

And TIL that there is a distinction between programming on the hardware and programming the hardware, might be something to look into