Great looking printer. I'm an owner of a B9, it seems the only disadvantage of the Formlabs if you can call it that is that the feature size can't be smaller than 300 microns. For any square, structural shapes the B9 has an advantage here as it can render x/y pixels down to 50 microns at the smaller build size and 100 micron pixels at the 4"x3"x8" envelope. In every other situation however, the laser of the Formlabs I'd think would have the ability to trace around any curved features with a higher level of precision as it's not limited by pixel density. SLA is a slower process as the laser has to fill in each layer until it can transfer to the next layer, whereas DLP projector-based tech cures an entire layer with each projection cycle. I think the B9 can do about an inch per hour depending on the properties of the resin formulation. Great to see you guys giving the monopolies some competition, don't sell out!